Homark hob ignition fault

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Homark hob ignition fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 7, 2004 at 6:23 pm #5338
    admin
    Keymaster

    🙁 My ignitor on my hob won’t stop clicking !!! Any suggestions to what the problem could be?

    April 7, 2004 at 6:28 pm #110661
    kwatt
    Keymaster

    Probably the ignition block faulty or the button/ one of the buttons stuck down locking it on. That’s about all it can be really, I would suggest isolating it from the mains and giving all the buttons/knobs a good clean off and try it again.

    If it persists it’s likely that the block is faulty that being the case you can look at a repair but it is gas so you’ll need a CORGI registered repairer.

    K.

    April 7, 2004 at 6:35 pm #110662
    Alex
    Participant

    Re: Homark hob ignition fault

    Chances are someone was a bit enthusiastic when cleaning, or some water has boiled over onto the spark generator.

    Sometimes, just leaving the hob switched off at the wall and leaving it 24 hours to dry sorts it.

    Time will tell.

    Alex

    April 8, 2004 at 7:32 pm #110663
    admin
    Keymaster

    Re: Homark hob ignition fault

    😀 Alex was correct. I loosened the ignition button and gave it a blast from a hairdryer (not too hot as I didn’t want to fry it!) and IT WORKS – Thanx – saved me time and money.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.