- This topic has 4 replies, 5 voices, and was last updated 16 years ago by
.
-
Posts
-
Occasionaly machine will work normally,then abort at any given time in cycle. Then on other occasions every prog other than Dry machine will drain initialy then aborts.Door lock clicks open as if cycle has finished.Wash/Rinse and spin symbols illuminate as at end of cycle. Suspect control board.Anyone come across this??
Re: Electrolux EWX14440W Cuts out
Had a Zanussi ZWF1440W doing very similar intermittent mularky.
Discovered that by shifting the loom near the module and p/sw around, it would work. Knew there must be a loose connection in there somewhere but wasn’t sure I’d be able to find it. So I found by experiment the position in which the loom worked consitently and tied it up in that position with cable ties. Charged for my work and told customer I’d look into price and availability of new loom. Well, that was last August. I never did quite find the new loom prices. Still keeping fingers crossed that repair will last till this August. 😆
Mike.Re: Electrolux EWX14440W Cuts out
Had a similar thing happening to an Indesit WIDL126s .. Turn out to be a trapped wire on the loom .. The wire was earthing out against the cable intermittently
George
Re: Electrolux EWX14440W Cuts out
you checked insulation of heaters….these suffer from low insulation dryer heaters ..normally E33/E32 on diagnostics??
- You must be logged in to reply to this topic.