- This topic has 2 replies, 3 voices, and was last updated 16 years ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
The machine seems to stop part way through any cycle and flash the 90 minute and stain vanish LED’s.
Sometimes i can select spin or drain and it will continue to a stop.
Does anyone have any ideas what could be causing this? I seem to remember someone mentioning the heater element could cause this problem and so i removed it and tested it with a multi meter. Sure enough it is open circuit but why would this cause the machine to stop working????because it needs to get to a set temperature before it will advance… since its a cold fill machine, it needs to heat the water up
just change it and all will be ok
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.