- This topic has 0 replies, 1 voice, and was last updated 16 years ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Put this through a 40 easycare was and it went through ok. Then tried it on a 60 easycare and after approx 40 minutes it was showing 1 minute to go on the display, and was overfilling as well (whilst activating the drain pump intermittently). P/switch/heater etc. checked ok. Motor does seem to be getting a bit warmer than usual, but hard to tell.
Are these a timed fill? I’m wondering about the PCB…
Trev
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.