- This topic has 2 replies, 2 voices, and was last updated 16 years ago by
.
-
Posts
-
Production No 40716124
Regardless of which program is selected, the dishwasher runs as normal until it gets towards the end of cycle.
Then the second led on the program indicators flashes, beeps and the circ pump turns once or twice. It just continues to repeat this sequence flash beep pump. (the m/c has got hot water in it at this stage)
Any ideas anybody?
Thanking you in advance.
Steve.
Re: Teka ADW7 59 F1 Dishwasher (is it a Smeg)
if its similar to the last teka i did it will be board s/w corruption. i offered to send it to emw but customer didnt think it washed well anyway so went for a new one instead (h/p :rolls:)
if you do send it off to emw (£29+vat if they can sort it – http://www.emwelec.co.uk) it would be worth asking them to note where the fault lied because detergent dispensers and solenoids can corrupt the pcb apparently (ask penguin) and its no good getting the board sorted and then having to do it again the month after…
- You must be logged in to reply to this topic.