hotpoint washers filling and draining as soon as prog starts

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint washers filling and draining as soon as prog starts

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 28, 2010 at 1:10 pm #54263
    scoobya1
    Participant

    have got a wd420 and a wml540, both fill and drain as soon as the programme starts and continue to do so. They are not syphoning. Any clues please

    April 28, 2010 at 1:21 pm #319013
    A1engineer
    Participant

    Re: hotpoint washers filling and draining as soon as prog st

    probably ntc fault, check wires at ntc if not needs a pcb

    April 28, 2010 at 2:41 pm #319014
    iadom
    Moderator

    Re: hotpoint washers filling and draining as soon as prog st

    If they start to fill on a spin programme then its 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain its the module.

    April 28, 2010 at 3:31 pm #319015
    garn
    Participant

    Re: hotpoint washers filling and draining as soon as prog st

    Just Left One Myself Continuous filling even In The 0 Position On The Selector Switch No Pump Or Motor Action 😥

    And The Stones Are Lose Looks Like Volcanic Dust All Over The Pcb 😮


    Garn

    April 28, 2010 at 3:57 pm #319016
    Allsorts
    Participant

    Re: hotpoint washers filling and draining as soon as prog st

    Check the two little blue NTC cables and the connectors on the module for bad connections

    George

    May 5, 2010 at 9:37 am #319017
    scoobya1
    Participant

    Re: hotpoint washers filling and draining as soon as prog st

    was the ntc, lucky this time, thanks!

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.