- This topic has 6 replies, 4 voices, and was last updated 15 years, 11 months ago by
.
-
Posts
-
Hi all, I have a problem where the machine fills then pumps back out again round and round in a loop but will not proceed any further and will not enter the wash cycle .
Any help would be great.There is a level float on this machine and the chances are that this is stuck or gunged up and so not rising when the water rises.
Take out the filters in the tub base . At approx the 5 o’clock position around the edge of thesump area you will see a small grey cover . Pop this off and remove the float from its tube. PLEASE NOTE THE ORIENTATION O THE FLOAT – I.E GREY SIDE UP , CLEAR SECTION DOWN .
Clean this float and also the area that the float runs up and down in. You may find it all clogged up with grease , fat and gunge. I sometimes pour a little hot water down here to release the greasy deposits.
Refit the float making sure it is the right way up , and then try the machine again. It should now work ok.Re: Bosch Dishwasher SGS43A42GB/01
i have the same problem with my Siemens Model SE24M851,
Can you advise of the location of the level float for this model?nomadPaul wrote:Take out the filters in the tub base . At approx the 5 o’clock position around the edge of thesump area you will see a small grey cover . Pop this off and remove the float from its tube.
P45.
Penguin45 wrote:
nomadPaul wrote:
Take out the filters in the tub base . At approx the 5 o’clock position around the edge of thesump area you will see a small grey cover . Pop this off and remove the float from its tube.P45.
Hello oh Flightless one 😀 , i have been in touch with the above poster…..its a model with the impellor jug and so have advised accordingly 😉
- You must be logged in to reply to this topic.