Zanussi ZWD1252W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWD1252W

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 4, 2010 at 8:18 am #55002
    Toni
    Participant

    Hi
    I have this job this afternoon, the fault is
    The machine fills & starts to wash, after a couple of minutes it stops with the start light flashing (no other lights)
    Drum turns ok
    Drains ok and it will spin if put on to a spin
    Could it be a heater ?
    I have not been there yet so any feed back would be appreciated

    Thanks
    Toni

    June 6, 2010 at 10:50 pm #321689
    leavemetogetonwithit
    Participant

    Re: Zanussi ZWD1252W

    Hah! I must have been too busy watching the subsea gusher.
    This is easy. Disconnect dryer heater. It’ll all work fine. Megger dryer heater on its own; it’ll be under 40Megohm ins res. If you’re to replace, get right one , two poss. one 2x 1000w , one 2x 700w IIRC.
    Mike.

    July 14, 2010 at 3:02 pm #321690
    Toni
    Participant

    Re: Zanussi ZWD1252W

    a bit delayed, but thanks that was spot on
    Toni

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.