Baumatic BDW13 Pipe disconnected at back

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Baumatic BDW13 Pipe disconnected at back

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 5, 2010 at 1:56 pm #55029
    cloudzilla
    Participant

    Hi everyone, hope someone can help with this…

    After repeatedly getting E4 (error code, not the tv channel) on my Baumatic BDW13 I took the side panel off to see I had a leak at the back of the unit. After following the source of the leak I found that the vertical flat pipe at the back had come loose and the seal had broken on it.

    I’ve attached a photo… do you think this is fixable?

    Thanks

    June 5, 2010 at 9:45 pm #321750
    clivejameson
    Participant

    Re: Baumatic BDW13 Pipe disconnected at back

    Nope…have seen this many times on various makes of dishwasher! The only cure is a new top feed tube but good news however is the particular pipe isn’t a very expensive part and the seal is re-useable. Be careful not to overtighten the plastic nut on the inside, really hand tight is good enough 😉

    June 8, 2010 at 3:55 pm #321751
    cloudzilla
    Participant

    Re: Baumatic BDW13 Pipe disconnected at back

    Many thanks for the advice!

    I checked with the spares department on UKWhiteGoods and apparently this is the part I need…

    http://shop.ukwhitegoods.co.uk/advanced_search_result.php?search_in_description=1&keywords=672030090014&x=27&y=9

    Do you know if it’s as simple as ordering that and it comes with all I need?

    Cheers again

    June 10, 2010 at 1:00 am #321752
    aqualectric
    Participant

    Re: Baumatic BDW13 Pipe disconnected at back

    Yes, just be sure to remove the little hose clamp at the bottom carefully as the hose it is clamping is attached to the heater. Try not to put any strain on this hose.

    A.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.