Indeset we12suk bearings

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indeset we12suk bearings

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 13, 2004 at 6:55 pm #5508
    streetlighter
    Participant

    Hi all
    got one of these tomorrow
    2 different sizes of spider 👿
    To top it of both seals c00096286 & c00082696 dont seem to exist.
    very confusing on partfinder gives different part no’s for rear bearing but the same size. 1 should be 22mm and the other rear bearing should be 26mm?????????????????
    I am very confused and I’ve not even been their yet.
    the part numbers on partfinder dont seem listed in any of my supplyers.
    connect,washvac,seme

    thanks for any help and advise on this and how easy they are to do.

    paul

    May 13, 2004 at 7:38 pm #111635
    Martin
    Participant

    Re: Indeset we12suk bearings

    Paul,

    Don’t envy you that job but I have done several in my time. (See my postings under Trade Technical Enquiries page 2 – Indesit W143 Bearing Change)

    Once you have the spigot out it is easy to knock out the 2 bearings (standard 6205ZZ and 6206ZZ) and fit a new Seal part No 082696 (fits other Indesit/Ariston models – fairly standard stock really)

    Word of warning ! Do not get too physical removing the spigot as you can easily damage the S/steel Drum 😥

    Martin

    May 13, 2004 at 7:53 pm #111636
    streetlighter
    Participant

    Re: Indeset we12suk bearings

    Thanks martin
    Just as well I like a challange isn’t it
    Dont like s/s drums since “that” candy one 😥

    May 14, 2004 at 9:59 pm #111637
    streetlighter
    Participant

    Re: Indeset we12suk bearings

    Thanks martin job done
    Nice little earner
    It did make it easyer nowing what to do and i see what you mean about the drum but it moved ok with only a little help.( cant spell perswasion )
    Had bearing and seal on van too.
    took 2 hours but next one may be quicker but I wasn’t in a hurry on this one.
    thanks again 😆

    paul

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.