- This topic has 4 replies, 3 voices, and was last updated 15 years, 10 months ago by
.
-
Posts
-
I was out to this on Monday, customers dad had changed the pump, and in the process managed to get water on the module, causing the machine to work but water pump running continuously.
I had a look at the module and the only sign of damage was one of the relays had shorted. I replaced the relay with one from from a donor board. Tried it on and everything was ok.
Customer has done a few washes Mon, Tues and Wed, but today phoned to say that the machine had not completed the wash and H20 was displayed on the front.
I have looked through the known error codes, but can’t see H20 among them. I am guessing it is referring to a water fault ie no fill or no drain.
Any ideas before I go back out to her?
Thanks
Re: Hotpoint WT746 – H20 fault code?
from “Known Error Codes”……
H20 – Not filling. Check tap, hose and inlet valves
Re: Hotpoint WT746 – H20 fault code?
😳 I better get to spec savers Martin, I didn’t see it. 😳
Cheers anyway 😉
Re: Hotpoint WT746 – H20 fault code?
Just been out to this and when I switched the machine on it made a lovely crack and tripped the electric.
On inspecting the module all the tracks around my original repair are burned and looks as if there may have been water/damp present.I have a couple of spare boards, but from different models, is it possible to change the eprom from one board to an other?
I did in the first place, offer to replace the board with an EMW one but the customer can’t afford it.
- You must be logged in to reply to this topic.