zanussi FJDR 1666W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi FJDR 1666W

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 5, 2010 at 4:54 pm #55649
    ddirect
    Participant

    Hi all have a zanussi fjdr1666w fills agitates jet system pump comes in runs for a further 5 mins or so then fills again (overfilling) then just stops
    programme lights still on and either the start pause light flashing or light above skip programme cant rember whch one. gone through diagnostics and err 33 comes up which is incongruence between pressure switches or module fault, anyone had same fault, and would it be one of the pressure switches or module, havent got any second hand bits to experiment with.
    thanks in advance. Darren

    July 5, 2010 at 8:02 pm #324616
    cab
    Participant

    Re: zanussi FJDR 1666W

    element to earth

    July 6, 2010 at 6:02 am #324617
    ddirect
    Participant

    Re: zanussi FJDR 1666W

    thankyou Cab. will give it an insulation test, if your right which i am sure you are, there must be only a slight amount of earth leakage as it does not trip rcd. thankyou.

    July 6, 2010 at 12:46 pm #324618
    cab
    Participant

    Re: zanussi FJDR 1666W

    very common fault E33

    July 8, 2010 at 5:02 pm #324619
    ddirect
    Participant

    Re: zanussi FJDR 1666W

    turns out this one is a board fault cab, heater ok, purchased new board and configured it machine is now ok. you where right about being related to heater though,presume heater relay on board may have been at fault.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.