Hotpoint DF23 Dishwasher no fill

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint DF23 Dishwasher no fill

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 6, 2010 at 12:18 pm #55673
    bmrenr
    Participant

    Hi have the above dishwasher and it will start off the cycle by pumping out as normal but when it comes to the next stage where it should let in the water it just stops dead and no power going to the inlet valve I have checked and there is no blockages and have tried another timer but still have the same prob. Any ideas ?

    Tom

    July 6, 2010 at 1:00 pm #324716
    timdowning
    Participant

    Re: Hotpoint DF23 Dishwasher no fill

    Did you check for broken wires where the door levers?

    Take the door off as you would have done when you changed the timer.

    Look at the loom. Bend it a bit as the wires can look ok.

    July 7, 2010 at 10:14 am #324717
    bmrenr
    Participant

    Re: Hotpoint DF23 Dishwasher no fill

    Cheers Tim you were spot on I did have a look at them and as you say looked ok but after your reply I had a closer look and sure enough one of the wires was broken . Thanks again.

    Tom

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.