bosch wfb 2004

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › bosch wfb 2004

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 26, 2010 at 1:50 pm #56097
    dom78
    Participant

    hi, just a quick enquiry, is the hot water inlet the lower or higher one on the back of this washer? was unplugged from the back of the machine rather than the pipes and the onling manual shows them side by side, which they are not. i don’t know if it actually makes a difference but i assume so. apologies if i posted this in the wrong place, first time!
    ta!

    July 26, 2010 at 2:02 pm #326206
    don
    Moderator

    Re: bosch wfb 2004

    Hi

    Can you post up the full ENR number please WFB2004GB/??


    Don

    July 26, 2010 at 2:04 pm #326207
    dom78
    Participant

    Re: bosch wfb 2004

    thanks for the reply! yeah i can, but it’ll be tomorrow, i’m away from the machine just now.

    July 27, 2010 at 5:29 am #326208
    dom78
    Participant

    Re: bosch wfb 2004

    wfb2004gb31

    July 27, 2010 at 7:27 am #326209
    don
    Moderator

    Re: bosch wfb 2004

    Online drawings show them to be side by side as well. If there is no physical way you can tell then I would connect hoses ( this is the 50:50 part 🙂 ) put no clothes in and set it to a rinse and spin or rinse programme, at the end of the cycle if the drum is warm inside then the hoses are the wrong way around as the rinse cycle should only allow cold water in.


    HTH 🙂

    Don

    July 27, 2010 at 7:30 am #326210
    dom78
    Participant

    Re: bosch wfb 2004

    thanks.
    there is a a slight difference in the colour of the plastics, one is more a solid white than the other, i’ll go with that and try it out on the rinse.
    cheers!
    dom

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.