Smeg DI612C

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Smeg DI612C

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 2, 2010 at 7:36 pm #56241
    ChrisR
    Participant

    Hi guys.

    I may have asked this question before but I see very few of these dishwashers mainly by choice.

    This one,after programme selection, pumps for a minute or so then fills for a few seconds then empties stops empties stops forever with a constant beep beep-beep.

    I seem to remember flow control problems with these but cannot remember procedures.

    Any help happily recieved.

    Thanks.

    Chris 😀

    August 2, 2010 at 10:35 pm #326670
    adv
    Participant

    Re: Smeg DI612C

    could be that but also check pressure switch grid in sump right hand side clear with small brush and maybe some boiling water 😆

    August 3, 2010 at 10:31 pm #326671
    ChrisR
    Participant

    Re: Smeg DI612C

    Checked that.Does`nt appear to be there on this model.

    Thanks.

    Chris.

    August 3, 2010 at 11:02 pm #326672
    adv
    Participant

    Re: Smeg DI612C

    had a look different type sorry. ave had that on one or 2 it was pcb. i sent it to qer to fix as board was very exspensive.these machines are a hit or miss sometimes tho 😳

    August 3, 2010 at 11:07 pm #326673
    ChrisR
    Participant

    Re: Smeg DI612C

    Thanks adv 😉

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.