Belling dishwasher IDW60i

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Belling dishwasher IDW60i

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • June 16, 2004 at 6:07 pm #5651
    cornwell40
    Participant

    Fault 04 no heat. Tested dishwasher and …yup no heat!
    Checked thermistor on front, stat, element and loom.All seem o.k.
    I’m pretty sure its going to be the dreaded board, but is there any other known fault on these that causes no heat.???? 😕
    Cheers
    Tony C

    June 16, 2004 at 7:02 pm #112640
    Penguin45
    Participant

    You might just hit lucky and find a dry joint at the relay on the board. Then again, you might not…….. Luck!

    Penguin.

    June 16, 2004 at 7:20 pm #112641
    Penguin45
    Participant

    Isn’t there a manual reset safety stat round the back of the sump moulding on these ones? If that’s tripped you’re more likely looking at a water level problem. Just an additional thought.

    Penguin.

    June 16, 2004 at 7:28 pm #112642
    cornwell40
    Participant

    Re: Belling dishwasher IDW60i

    Iv’e not noticed one but it is something I was on the lookout for.
    On the rear of the sump?I’ve had the panels off and nothings visible on this one.
    Had that one a few times though usually the customer has”just tried a little washing up liquid in it cos we ran out of detergent” 🙄 . My how we laughed.
    Then they got the bill 😈

    June 16, 2004 at 8:34 pm #112643
    Penguin45
    Participant

    True. A dash of fabric conditioner kills the bubbles (but don’t tell everybody).

    Penguin.

    June 24, 2004 at 5:08 pm #112644
    cornwell40
    Participant

    Re: Belling dishwasher IDW60i

    Good and bad!
    Fault correctly identified as heater circuit on board (thank you QER) 😀

    Erm….Prat of an engineer 🙄 (me) made one of my connection marks on a component that was replaced . 😳
    Anyone got a wiring diagram for one of these or know which way round the heater relay (white / brown) wires go.
    😳
    Tony C

    June 28, 2004 at 8:11 am #112645
    cornwell40
    Participant

    Re: Belling dishwasher IDW60i

    Sorted.
    Apparently didn’t matter which way around they fitted 🙄 (thank QER) but better to check anyway.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.