Smeg Dishwasher Not Draining

Home Forums Public Support Forums Help And Support Dishwasher Help Forum Smeg Dishwasher Not Draining

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #5657
    mischievous
    Participant

    🙁
    I have a Smeg Dishwasher, Type 10135, Model DWF 44 SS.1, Nr 06535 0502

    The dishwasher will move through a cycle normally but at the end of the cycle there is water still in the bottom of the dishwasher.

    Cannot hear the pump going at any stage during cycle so think that the pump may have gone. Have checked filters in the dishwasher and the connection hoses for kinks and no visable problems.

    Any other suggestions?

    Recommended Smeg service in London (SE11)?

    Thanks

    #112667
    admin
    Keymaster

    Re: Smeg Dishwasher Not Draining

    In my opinion it would appear that the waste pump has failed( I myself have one of these and in the past 3 yrs i have had to replace it 3 times..not a happy chappy.)

    bryan
    😈

    #112668
    mischievous
    Participant

    Re: Smeg Dishwasher Not Draining

    Thanks 😕 🙁

    Have had it about 18 months, how much did it cost to replace?

    #112669
    admin
    Keymaster

    Re: Smeg Dishwasher Not Draining

    The cost of the part would be approx £30 – £40 plus labour but it depends on the engineer ect.

    bryan

    #112670
    admin
    Keymaster

    Re: Smeg Dishwasher Not Draining

    NO INSTRUCTIONS for my smeg DWF 44 SS.1
    where may i get them from plz..

    #112671
    Dave_Conway
    Participant

    Re: Smeg Dishwasher Not Draining

    dragoness.joy@gmail.com wrote:NO INSTRUCTIONS for my smeg DWF 44 SS.1
    where may i get them from plz..

    You can download them from Smeg, if you hit the link below it will download the pdf for your model, I just found it for you 😀

    http://www.smegtech.com/site/smeg/pdf_l … 100-GB.pdf

    It’s just over 2mb so it may take a while if you’re not on Broadband 😉

    Dave.

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.