- This topic has 5 replies, 4 voices, and was last updated 15 years, 7 months ago by
.
-
Posts
-
Hotpoint Bwd 129
Replaced PCB, Better but still a fault so replaced display Board.
All seemed to be perfect, But as I was putting lid on,Heard Dryer Water valve
filling and found live supply to valve when on/off on, But not started.
I have taken machine to workshop and tryed another PCB I had ordered for another machine, Its still the same, all the tags are in perfect condition.
I have run out of ideasRe: bwd129 Live to Dryer water valve, when not started
have you checked for earth faults
most components are fed live and neutral switched so if you have a small leak to earth valve will energise
Dave
Re: bwd129 Live to Dryer water valve, when not started
Both live and neutral feeding valve from PCB
I cannot find any down to earth problems.
I am completely out of ideasRe: bwd129 Live to Dryer water valve, when not started
Plug-in connections on board incorrectly located maybe? 💡
Re: bwd129 Live to Dryer water valve, when not started
I am reminded of how water valves come into operation on WMA’s during spin when brushes down. Have I remembered that right? Anyway, worth a look. Could try unplugging motor and see if it’s any better.
Mike.
- You must be logged in to reply to this topic.