ISE 5/2

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE 5/2

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 1, 2010 at 12:51 pm #56929
    Toni
    Participant

    Hi
    I have one of these that doesn’t spin
    The drum turns ok on the wash & just tumbles slowley on the spin
    She says the timer doesn’t count down either, although it did when I checked it
    It drains ok & pressure chamber is fine (All clean)
    I checked all connections & they seem ok
    Can anyone help? could it be the module ?
    Not had te repair too many of these so not that familar with them

    Thanks
    Toni

    September 1, 2010 at 9:02 pm #329302
    Steven
    Participant

    Re: ISE 5/2

    I had one recently, variable spin dial had been accidently turned to 0ff. 😳

    Steven

    September 2, 2010 at 5:53 pm #329303
    boselecta
    Participant

    Hi Toni

    Had a few of these machines with out of balance load problems, redistributing seems to cure it, putting more items in normally.

    Failing that can only think the base motor control board could be faulty.

    September 2, 2010 at 7:37 pm #329304
    cornwell40
    Participant

    Re: ISE 5/2

    Had a similar fault and a wire to the motor plug had broken inside the insulation. Would do a slow 500rpm ish spin then wouldn’t ramp up any further.

    TC

    September 3, 2010 at 6:07 pm #329305
    Toni
    Participant

    Re: ISE 5/2

    Went back & made sure all connections were tight again & machine now works 😀
    Thanks for the reply’s anyway

    Toni

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.