- This topic has 4 replies, 4 voices, and was last updated 15 years, 6 months ago by
.
-
Posts
-
This m/c is freezing during a wash, the customer left it for me today and it had advanced to the final rinse. You have to switch it off for it to restart and selecting the X will not reset when the start button is pressed. Once off it will continue from were it stuck.
Had similar thing with this at the start of the year, replaced the main pcb and it resolved. Seems strange it has failed again.
Checked the usual suspects and the m/c cones back fine?
Re: Bosch WFT2800/13
S1MON wrote:Had similar thing with this at the start of the year, replaced the main pcb and it resolved. Seems strange it has failed again.
You replaced the main PCB? 😯 Bl**dy Nora, they’re over £230…!!! 😥
When it sticks are any of the LED’s flashing by any chance?
Main suspects are: –
Motor brushes…..
Gunge in air chamber………
Duff inlet valve coil…………
Earth leak on dryer blower fan motor………..My money is on the motor being the problem but let me know if any LED’s show up when it shuts down…OK?
No lights flashing
Brushes are fine, motor readings are high
Checked inlet valves all ok
Cleaned out air chamber
Havent checked the dry motor, she never uses the drying side so ill check thatCheers
Re: Bosch WFT2800/13
S1MON wrote:selecting the X will not reset when the start button is pressed.
Never have found one where that worked 😕 .
Could be a brush sticking or making intermittent contact due to wear. (In case you just checked continuity.)
Mike.
- You must be logged in to reply to this topic.