whirlpool awz480e dryer.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › whirlpool awz480e dryer.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 15, 2010 at 3:41 pm #57268
    DRH
    Participant

    heater stats gone again! 3rd set!
    dryer has good air flow, its all clean inside
    out side vent,no blockages.
    its not overloaded .
    could the motor run slow?
    help!!!! 😕

    September 15, 2010 at 4:36 pm #330445
    SimonCD
    Participant

    Re: whirlpool awz480e dryer.

    Dodgy cap?

    September 15, 2010 at 5:55 pm #330446
    johnmac11
    Participant

    Re: whirlpool awz480e dryer.

    has it got a 5″ metal vent hose? I have saw a few with a normal domestic 4″ hose which causes this problem.

    John

    September 16, 2010 at 12:32 pm #330447
    DRH
    Participant

    Re: whirlpool awz480e dryer.

    its got the real vent hose.air flow spot on! :rolls:

    September 16, 2010 at 12:39 pm #330448
    johnmac11
    Participant

    Re: whirlpool awz480e dryer.

    Is it in a old folks home?? saw a few doing this and it was down to staff opening the door during the program and not letting the cool down take place.

    John

    September 16, 2010 at 12:46 pm #330449
    DRH
    Participant

    Re: whirlpool awz480e dryer.

    no its in a large vets. told them to leave well alone until end of prog. its on its third set in about 10 days now.poor old dom/gen.

    September 16, 2010 at 2:52 pm #330450
    electrofix
    Moderator

    Re: whirlpool awz480e dryer.

    if you tap stats on the floor they can be reset

    must be an airflow prob check that the exhaust air is not getting recirculated or dryer is not in very hot room ie boiler room

    exhaust stat / cabinet stat ?

    causing drum to overheat

    just a thought

    Dave

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.