Hotpoint CTD85 – Wont start program

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint CTD85 – Wont start program

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 15, 2010 at 5:12 pm #57272
    nelson
    Participant

    🙁 I don’t think it is my week.

    Called out to this one earlier in the week, no power, when I checked it seems the neutral runs through the TOC then back to the module. The TOC was on inspection was O/C, and I noticed that the element was in a pretty poor state although still working, looked like it wouldn’t stand up to much handling.

    So I ordered a new element and went to fit it today, once it was fitted I did have power to the display, which allowed me to set a drying program but would not start.

    Does the machine need to be reset somehow or is there something more major I need to replace such as the module?

    Please help turn my frown upside down.

    September 15, 2010 at 6:57 pm #330455
    helo_75
    Participant

    have you checked the activation pin, on the inside of the door?

    September 16, 2010 at 9:26 am #330456
    nelson
    Participant

    Re: Hotpoint CTD85 – Wont start program

    The door activation pin is ok, I should have mentoined that when the start button is pressed it beeps three times, also pressing and holding the start button (to cancel a program) also causes the machine to beep three times. 😕

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.