HP DISHWASHER DF53

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HP DISHWASHER DF53

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • June 29, 2004 at 10:14 pm #5729
    ace
    Participant

    Hi all,
    Not got the machine out to check it at the moment. The fault is that the water valve is activating as soon as it is switched on, and will fill to overflowing. No matter what position the switches are in it disregards them and carries on filling. Is there an overide sequence on this model.

    Thanks, ACE ❓

    June 29, 2004 at 11:29 pm #113326
    Penguin45
    Participant

    DF53 is a digi Bosch-clone IIRC – most likely triac failure on PCB. Can be valve failure, but unlikely with Eaton type valve.

    Penguin.

    June 30, 2004 at 7:17 am #113327
    Martin
    Participant

    Re: HP DISHWASHER DF53

    Actually the DF53 is a Creda made machine not a Bosch clone. Possibly the Heating Element is shorting to earth thus supplying a feed to the inlet valve 😉 Also the wiring loom is a suspect, access is tricky though 🙄

    Martin

    June 30, 2004 at 7:39 am #113328
    Dave_Conway
    Participant

    Re: HP DISHWASHER DF53

    It’s actually a Brandt made dishwasher. Exactly the same as the MFI AHY8101/8102.

    As Martin said, check the heater for earth leakage, wiring is unlikely as the timer is “down under” so no “hot” leads in the door hinge area.

    Dave.

    June 30, 2004 at 5:02 pm #113329
    eastlmark
    Moderator

    Re: HP DISHWASHER DF53

    Yeah, back up Dave and Martin, the Heater causes all sorts of odd faults on this one, disconnect it (its right at the front once the front panel under the door is off). You should also be able to click the timer on using a torx screwdriver and they even include a timer disc in the bottom moulding, assuming another engineer hasnt knicked it. Dont forget to re set the timer to the end of programme position otherwise you will get a recall as the start button wont work.

    June 30, 2004 at 6:05 pm #113330
    Penguin45
    Participant

    Got that wrong, didn’t I. Am I thinking of DF64?
    Is Brandt now what used to be CSF Thomson?
    Regards,
    Penguin.

    July 1, 2004 at 7:28 am #113331
    Dave_Conway
    Participant

    Penguin45 wrote:Am I thinking of DF64?

    Dunno, there’s no such model 😆

    Penguin45 wrote:Is Brandt now what used to be CSF Thomson?

    Yep, they still use the Thomson name in Europe I believe.

    Dave.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.