whirlpool cold inlet valve

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › whirlpool cold inlet valve

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 17, 2010 at 7:45 pm #57317
    sourfacedsod
    Participant

    got a problem with my washing machine. switched on came up with error code (fh – no water entering machine) (hot water ok ) i’m assuming it’s the inlet valve that’s away away does anyone know the best way to test it any info would be really helpful thanks. no problem with hoses or water valve, filled a bucket in seconds.

    September 20, 2010 at 9:43 am #330597
    electrofix
    Moderator

    Re: whirlpool cold inlet valve

    its normally the coils that fails on valves

    you need a multimeter on ohm scale and you should get between 3 to 5000 ohms

    if you check the hot the cold should give a similar reading

    (test with plug out no power on machine)

    Dave

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.