Hotpoint Dryer Mod TCD970P

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint Dryer Mod TCD970P

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 20, 2010 at 5:59 pm #57363
    smeghead
    Participant

    After 10 mins , Error F07, All option lights flash, but machine continues to run.
    Done all usual checks, gunge in pumping tank base, cleaned out but error still occurs.
    Any Help appreciated. Clive.

    September 20, 2010 at 6:51 pm #330943
    BobHope
    Participant

    Re: Hotpoint Dryer Mod TCD970P

    F07 Lower element failure • Check security of module connector J4;
    • Test between pins 4 and 3 on J4 (approximately 48 Ohms);
    • If open circuit, test lower element and wiring between J4
    and the heater.

    Bob.

    September 21, 2010 at 7:40 pm #330944
    smeghead
    Participant

    Re: Hotpoint Dryer Mod TCD970P

    Thanks for that Bob, seems to heat OK but will check connections on module & recheck heater resistance.
    Clive.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.