Comenda Dw leak

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Comenda Dw leak

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 21, 2010 at 9:47 pm #57402
    DDDave
    Participant

    I called to a Comenda LF322 dw today, customer says it is leaking from the door. I put it through 4 cycles without it leaking. I could see water at the bottom lip of the door though. The water level is well below this lip so I think the spray arm is causing this. There is a seal across the top of the door but none on the sides or bottom. Is this correct ?? Any ideas please ??

    Thanks

    Dave

    September 22, 2010 at 10:00 am #331010
    electrofix
    Moderator

    Re: Comenda Dw leak

    most industrial washers have no seals but are made in such a way as to trap water and let it run down the door

    check drain to make sure water is not too high
    rinse aid over dosing causes foaming and leaks
    bottom of door lets and right hand side look for blockages grease build up or the like that might stop water flowing into tank
    check paddles for blockages if jets are blocked the remaining jets are more powerful

    for parts and info email parts@comenda.eu

    this is in italy and ask for a parts supplier where you are.

    In UK it is Dawson 01226 350450

    Dave

    September 22, 2010 at 12:39 pm #331011
    DDDave
    Participant

    Thanks Dave.

    I have done all the above checks and everything was ok thats why I was wondering if there should be seals.I will email comenda for a parts diag to check .

    Cheers

    Dave

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.