- This topic has 6 replies, 3 voices, and was last updated 15 years, 6 months ago by
.
-
Posts
-
Hi,
I know this is a simple fault but its driving me mad.
Its a hotpoint wt960 and its not taking conditioner. I put it on the rinses and waited 20 mins to get to the right part but it just fills in the powder compartment. There are no blockages in the jets in the roof, which i’ve had loads, and the water valves seem to be reading correctly.
There are no fault codes produced and the machine does go through to the end.
Has any body got any ideas or is it a pcb.Many thanks
Nick
Re: Hotpoint WT960 Not taking conditioner
Is yours the version with seperate valve or that integrated valve?
Re: Hotpoint WT960 Not taking conditioner
It’s the version with the double valve but it pushes into the dispenser unit.
Re: Hotpoint WT960 Not taking conditioner
Sorry to highjack your post grooster but do you know a affective way of cleaning out the channels inside those housings, Ive got an indesit not taking conditioner to look at ❓
Re: Hotpoint WT960 Not taking conditioner
I put a really long cable tie up the holes to clean it out.
Re: Hotpoint WT960 Not taking conditioner
grooster wrote:It’s the version with the double valve but it pushes into the dispenser unit.
Well on the assumption there’s plenty of cold water pressure and the channels are clear I think it’s best to replaced the valve and see if that sorts it.
- You must be logged in to reply to this topic.