Hoover HNWL7166-80 11 flashes.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HNWL7166-80 11 flashes.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 20, 2010 at 9:28 am #58145
    aqualectric
    Participant

    Hoover HNWL7166-80 washer drier. No:- 3100135900471148.

    Fills, drains, spins. Heater, motor, drier heater and everything checked for earth leaks – all OK. Machine will start a program, run for about ten minutes and then stop with the Delay and Start leds flashing. Flashing 11 times then pause….drier heater problem says the fault codes. All the drier parts function fine and earth test OK, so is it the PCB? Have I missed the obvious?
    The part number for the PCB would be useful as well.

    Thanks,

    Steve.

    October 20, 2010 at 11:36 am #333533
    Martin
    Participant

    Re: Hoover HNWL7166-80 11 flashes.

    aqualectric wrote:drier heater problem says the fault codes.

    Dryer module or related wiring says the ERROR CODES

    aqualectric wrote:The part number for the PCB would be useful as well.

    Dryer Module = 41012524

    HTH? 😀

    October 21, 2010 at 9:02 am #333534
    aqualectric
    Participant

    Re: Hoover HNWL7166-80 11 flashes.

    Martin wrote:

    aqualectric wrote:
    drier heater problem says the fault codes.

    Dryer module or related wiring says the ERROR CODES

    aqualectric wrote:The part number for the PCB would be useful as well.

    Dryer Module = 41012524

    HTH? 😀

    Thanks Martin – but there is no separate drier module; it’s a single PCB only type. There are 2 variants of HNWL7166 hence the question. Also that part number 41012524 is the push button board on the facia….. 😕
    So I assume it’s the PCB then. The machine has no other discernable faults or earth leaks, so it’s Hobson’s choice, I suppose.

    Thanks,

    Steve.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.