Hotpoint WT960p F01.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WT960p F01.

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • October 22, 2010 at 11:57 am #58209
    allan73
    Participant

    Replaced the board on this a couple of months back and now it’s F01.
    Tony (EMW) say’s boards gone west because the motor is shorting but it test’s >550megg on all pins.

    Has anyone else had this on these 3 phase motor’s ❓

    October 22, 2010 at 6:31 pm #333737
    helo_75
    Participant

    yes, its quite common but its worth checking the wires in the motor plug first.

    the pcbs are just unreliable

    October 22, 2010 at 7:30 pm #333738
    allan73
    Participant

    Re: Hotpoint WT960p F01.

    Thanks.

    October 22, 2010 at 8:45 pm #333739
    leavemetogetonwithit
    Participant

    helo_75 wrote:

    the pcbs are just unreliable

    Seems a bit mild 😕
    Don’t let ’em get to you, Charlie 😆 .
    Mike.

    October 23, 2010 at 10:45 am #333740
    allan73
    Participant

    Re: Hotpoint WT960p F01.

    I’ve been told there are two 7 pin 3 phase motors for these, one with a 50mm stator & one with a 60mm.

    Does anyone know if they’re interchangeable ❓

    October 23, 2010 at 3:28 pm #333741
    helo_75
    Participant

    unfortunately not, diffferent manufacturers, and different eprom files.. u need to physically look

    October 23, 2010 at 6:28 pm #333742
    allan73
    Participant

    Re: Hotpoint WT960p F01.

    Don’t suppose there’s any way of bench testing these motors, with them being 3 phase ?

    October 24, 2010 at 6:54 pm #333743
    leavemetogetonwithit
    Participant

    Re: Hotpoint WT960p F01.

    “Shorting motor” could also mean a coil gone L-N short?
    You quite often see the small Merloni 3-phase motors on e-bay from machines which have had drum failure. They usually remain unsold at 99p, though going rate for carriage is a tenner.
    Mike.

    October 25, 2010 at 6:35 am #333744
    allan73
    Participant

    Re: Hotpoint WT960p F01.

    I could test the windings for the correct resistance with a multimeter I suppose, but I suspect it’s shorting when it’s in motion 😡

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.