Maytag G32026PELB 2door centre opening frigde freezer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Maytag G32026PELB 2door centre opening frigde freezer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 22, 2010 at 1:26 pm #58211
    refcol
    Participant

    Can anyone pls give me some info? This unit has had top pcb and probe in fridge ceiling because relay was sticking! all ok, setup code inputted, powered up ok, air flow valve operates for approx 1 min, comp starts up ok after a short while evap fan comes on then goes off until evap is cold enough, then fan on… i was only following previous engineer visit to fit parts? call came back in today and frigde only reaching 10 degrees. and freezer @ -24.. so checked frigde probe resistence/temp all good.
    Question… my colleague has not checked freezer probe? if the freezer thinks it’s not satisfied would this stop the fridge airflow valve from operating?
    If.t anyone could give me service info that would be great.

    October 22, 2010 at 2:40 pm #333747
    oldlonely
    Participant

    Re: Maytag G32026PELB 2door centre opening frigde freezer

    Hi,

    Which Relay do you mean? and where?

    O’l

    October 26, 2010 at 8:45 am #333748
    refcol
    Participant

    Re: Maytag G32026PELB 2door centre opening frigde freezer

    I am presuming there is a relay on the top pcb in fridge ceiling, because when i fitted new PCB comp started up and was switching normally except at 10 degrees in fridge?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.