- This topic has 3 replies, 3 voices, and was last updated 15 years, 4 months ago by
.
-
Posts
-
Trips power after about a minute.
had heater outer seems nothing wrong with it.
On top of drum are 2 carbon pieces and the centre bit that holds them together is rubbing on drum and making quite a raket. In fact it tripped when the drum started to reverse.
Is it possible that the carbon bits being worn is the problem.
I dont understand what they are there for . Someone said its todo with the heat sense in the drum.Any help please.
Mike
Re: Miele T650C Tumble Dryer
They are the automatic sensors of the dryer, if you look carefully you will notice that the drum is electrically insulated from the paddles, a resistance measurement is taken & electronics switch heater according to programme selected. Sensing is low voltage so shouldn’t trip a tripswitch if that’s what you mean. More likely to be motor, or heater fault.
Re: Miele T650C Tumble Dryer
condensor dryer check lower base fan for condensation very common in making these trip out! the fan onlt comes on after a few mins? either dry this out or replace if too far gone? check condensor box seals as this lets steam get onto this fan moter! hope this helps?
Brian 😉
- You must be logged in to reply to this topic.