- This topic has 2 replies, 2 voices, and was last updated 15 years, 4 months ago by
.
-
Posts
-
Any help appreciated.
Got this dryer when its first started that day it starts as normal runs for about 10min with no heat at all then beeps clean filter and empty water container flash to say its finished. Then you switch it back on and it works perfect heats up, tumbles both ways, pumps out, dryers clothes perfect etc etc. Does not matter how many times you try it it will work perfect from then on in leave it overnight and then it goes through same sequence again.
I’ve metered/meggared the element motor etc all perfect. ntc/senser meters ok rises/decreases with heat/cooling etc.
Tried a 2nd hand board i had knocking about still exactly the same fault. I know i can’t trust a 2nd hand board but if it showed up a different fault at least then i would have a good idea it was the board but it was still the same.
Perhaps i can’t see the wood for the trees on this one but i can’t find the problem and once it’s switched off then back on will work perfect and everything meters great so makes it even more difficult.
Is it the pcb/board? stat/sensor?
Thank you.
Phil
is it in an outhouse/ garage/ cold room
sounds like ambient temperature lock out to me
but if its indoors, its the front ntc thats at fault
- You must be logged in to reply to this topic.