Maytag G32026PELB

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Maytag G32026PELB

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 8, 2010 at 10:47 pm #59448
    don1407
    Participant

    Hi, got a pcb to ft to this and am after some advice on removing the housing in fridge, I am sure this is the trilogy with double doors @ top and drawer below for freezer.I saw one a while ago and am sure housing not screwed in but clipped in somehow.
    Any tips or advice would be great
    Thanks in advance
    Ian

    December 9, 2010 at 8:02 am #338222
    geoff1
    Participant

    Re: Maytag G32026PELB

    Ian

    I did one of these a while back and it was not a problem with fitting the board into the unit.
    The problem comes when having to program it. I found the instructions to mine by removing the kickplate and searching in the small gap in the condensor area.
    Without these for mine it would not start the unit up. Not sure if this the same in your case.

    Geoff

    December 9, 2010 at 5:09 pm #338223
    ELDAR59
    Participant

    Re: Maytag G32026PELB

    hello ian, did you get sorted?

    the housing that the pcb sits in is clipped to the top of the liner.
    the clips are accessed from the inside out if you know what i mean.

    cheers.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.