- This topic has 0 replies, 1 voice, and was last updated 15 years, 4 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
AWZ135
857513515020
Vented drier with large pcb control on the right of the m/c
This m/c will randomly bleep through the cycle on the sensor dry program. The m/c has had the pcb replaced recently this didnt cure the issue.
I went to the call and found that there was virtually no airflow getting outside. The hose has crushed so i sorted that, replaced the heater assmebly as that was going to earth and it has been fine for 6 weeks.
Went back yesterday and its doing the same again?
I cleaned the sensor bar at the front, checked airflow again, had it running for 30mins with no problems but customer rung today saying it has started again…
Any ideas?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.