- This topic has 5 replies, 5 voices, and was last updated 15 years, 3 months ago by
.
-
Posts
-
Called to this dishwasher about a week ago, showing E30 I pulled the machine out ,set a cycle it woked ok…call today same fault E30 dont know this fault but beleive its a fill / drain problem.. been told by customer the first time the fault occured the pump ran for a while then fault appeared..this time the fault code appears stright away then a noise like the pump runs after!!!
any advice would be welcome !!!
thanks JohnRe: AEG 60870 PNC 911 232 542 04
Usually a not draining quickley enough fault!
Check the usual, IE Plumbing spout, kinked hose, filters, pressure switch hose/ switch.Ian
Re: AEG 60870 PNC 911 232 542 04
Pressure switch faults are E30s, can sometimes be as simple as a filter blockage. Overdosing of detergent can cause pressure vessel to be giving a false reading. If you go into diagnostics you can get more specific fault code, also in service mode do a fill & empty a few times, see if it resets o.k .
Re: AEG 60870 PNC 911 232 542 04
there was a problem on the hose at the front of the sump to the pressure switch/air chamber sagging, therefore holding water in it, and keeps the pressure switch in a full position, make sure the hose is clear of gunge, and it is straight, or slightly tappering back to drain any residue back to the sump, it gave that fault code. a tie tag is normally used in keeping the hose from sagging.
another possible cause.
TELL..
p.s you can check this from the front bottom panel.
- You must be logged in to reply to this topic.