Hotpoint WF 860

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF 860

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 19, 2010 at 4:59 pm #59680
    A1TEC
    Participant

    Checked the search on this machine but could not find similar fault.

    Done the bearings on this one and fitted new heater, tested on all programs every think o.k.

    Connect at neighbours house three doors up and found that the machine fills on the 40 deg wash and time starts at 1hr 25.
    At 1hr 23 it trips the r.c.d, changed heater again but still has the same fault.
    Any help appreciated.

    John.

    December 19, 2010 at 6:19 pm #339244
    A1engineer
    Participant

    Re: Hotpoint WF 860

    did you change ntc as well??

    id have a look at wiring especially around motor and concrete weght

    December 19, 2010 at 8:12 pm #339245
    A1TEC
    Participant

    Re: Hotpoint WF 860

    No used the old one as it was a differant connection.
    Would the faulty ntc cause a dead short to trip the breaker?

    December 20, 2010 at 8:16 am #339246
    Allsorts
    Participant

    Re: Hotpoint WF 860

    Check water inlet solenoids ..

    George

    December 20, 2010 at 10:48 am #339247
    A1TEC
    Participant

    Re: Hotpoint WF 860

    Changed the ntc, still tripping breaker. 😕

    December 31, 2010 at 8:17 am #339248
    A1TEC
    Participant

    Re: Hotpoint WF 860

    Problem found. 😀
    Mains filter/lead was the problem, funny that it would run o.k for two mins then trip. 😕


    John.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.