- This topic has 3 replies, 3 voices, and was last updated 15 years, 3 months ago by
.
-
Posts
-
hi guys hope everyone has had a good xmas and im back out on the racetrack today with a hoover w/m thats no motor action, its brushless motor checked large pcb and has a fuse thats blown, iv not replaced as yet as never seen this fault, anyone had this before? cautious about just popping in a new fuse?
thanks simonb
Re: hoover vhd9143zd
Had one today too. It had blown the fuse and a large hole in the side of the component screwed to the large heatsink. Only £195 for a new board 😯
Re: hoover vhd9143zd
dont put a fuse in it it will go bang trust me 🙂
The fuse identified as M in Picture 2, is protecting the Core Board from fire. In case it’s
found burned out, it cannot be replaced but must be replaced the whole Core Board.
Ref. in
Pic. 2
Type of Electronic
Component on Board
Electromechanical controlled Component
simonb look in your in box 🙂
- You must be logged in to reply to this topic.