ISE5

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE5

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 5, 2011 at 3:52 pm #59959
    DrDill
    Participant

    Any help please with this fault:- Select wash program, fills to level, one tumble in each direction, then goes dead. Select spin, drains all water out tumbles once in each direction then no drum action and just the pump going,. We had this fault once before and changed the inverter board so tried this, still no go.
    Any ideas please.

    January 5, 2011 at 4:31 pm #340219
    kwatt
    Keymaster

    Not seen that one.

    I assume this is an ISE5-2?

    Motor not shorting is it?

    K.

    January 5, 2011 at 4:49 pm #340220
    DrDill
    Participant

    Re: ISE5

    Yes it is, the one with the boards at the bottom. I must admit i am scratching my head, assumed that the inverter board was faulty, but not. All electricals have been meggered, all okay. Its one of those which will be a simple fault but just cant see it! 😕

    January 5, 2011 at 6:54 pm #340221
    Lawrence
    Participant

    Re: ISE5

    DrDill wrote:Its one of those which will be a simple fault but just cant see it! 😕

    Aint they the worst ,once had a Servis doing somethig similar it was the heater if I recall ,but if you’ve meggered everything..
    unless its an edge connector ..

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.