- This topic has 2 replies, 2 voices, and was last updated 15 years, 2 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Motor makeing a rough grumbling noise on distribute and not spinning. Tried a second hand motor which was no different so ordered recon. board. Fitted and tested ok but first time cust. used it the fault returned.
Is this a common fault? found one similar thread but no one had answered it.
Meggered motor and heater, all seem fine. Any suggestions !!!Re: Hotpoint WT761 3 phase motor
what type of motor and software version are fitted to your appliance
Bob.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.