indesit Dryer DRUM Horrer

Home › Forums › General Trade Forum › indesit Dryer DRUM Horrer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 23, 2011 at 11:27 am #60436
    garn
    Participant

    Hi
    Just Refurbing A Indesit IS60Ventid Dryer 14 Months Old.

    Iv Just Finished Fitting A V4 Bearing .Shaft K

    Just Gone To Fit The Drum Shaft. To My Horrer The Shaft Has Been Prodused As Part Of The Drum..

    Had To Take It Back To The Workshop And Get A 9Inch Angle Grinder To Saw it off.
    The Locacating Holes Are Still There To Replace Another Shaft

    ❓ Are The Condenser Drum Shafts The Same Now.

    From Now ON Will I Have To Carry A 9inch Angle Grinder On The VanTo Be Able To Complete The Job On Site 🙂

    January 23, 2011 at 12:15 pm #342142
    helo_75
    Participant

    discussed to death already

    yes the condensers are the same

    http://www.ukwhitegoods.co.uk/modules.p … ic&t=60929

    it started off as beko drum paddle, and turned into another indesit bashing thread!

    January 24, 2011 at 10:15 am #342143
    leavemetogetonwithit
    Participant

    Re: indesit Dryer DRUM Horrer

    Why bother with the angle grinder? Just tell the customer to use it as is for another week and the shaft will be sawn off just nice. 😆
    Mike.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.