h/point dw fdm550

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › h/point dw fdm550

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • January 23, 2011 at 7:27 pm #60440
    clockworkone
    Participant

    does anyone have fault codes and wiring diag for this one.no heat reported.completes program ok.does this have ntc in door like fdw,s.regards paul

    January 23, 2011 at 8:32 pm #342149
    iadom
    Moderator

    Re: h/point dw fdm550

    You should be getting error codes but the heaters on these are just as bad as the previous ones only this time they are part of the circulation pump assy. 😥

    Check your inbox. 😉

    Jim.

    January 23, 2011 at 10:42 pm #342150
    clockworkone
    Participant

    Re: h/point dw fdm550

    thanks for that jim.

    January 24, 2011 at 1:08 pm #342151
    clockworkone
    Participant

    Re: h/point dw fdm550

    update on this one.went to look today,checked res and ins on heater all good,ntc fine and not come astray,connections all seem good.still going through cycle fine just no heat.no codes flashing either.wondering is it relay on power module.m/c only 18mths old.paul

    January 24, 2011 at 6:20 pm #342152
    iadom
    Moderator

    Re: h/point dw fdm550

    No heat on Indesit machines is normally 49{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} heater & 49{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} PCB. 😥

    I think this one may need a smart card to programme the PCB though. :rolls:

    January 24, 2011 at 6:28 pm #342153
    clockworkone
    Participant

    Re: h/point dw fdm550

    thanks again jim,yes it is a smart reader one,was wondering if relay on these can be replaced without having to reprogramme after disconnecting.paul

    January 24, 2011 at 9:20 pm #342154
    iadom
    Moderator

    Re: h/point dw fdm550

    Not heard of anyone having a go at one of these yet, don’t think EMW do them ATM.

    Jim.

    January 24, 2011 at 9:28 pm #342155
    HotDog
    Participant

    Re: h/point dw fdm550

    there is a problem with door harness routed over rather than under a support at bottom of door causing damage to harness so i have heard

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.