Samsung p1453 pump

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Samsung p1453 pump

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • January 28, 2011 at 1:37 pm #60590
    allan
    Participant

    Have to replace a pump on the above machine, although it is an askol pump, looks different to most i have fitted, still has three screw fitting to chamber, would a normal askol fit or is there something special about this one?
    Thanks Allan

    January 28, 2011 at 8:53 pm #342828
    allan73
    Participant

    Re: Samsung p1453 pump

    A run of the mill askol should fit but might be worth checking if the original pump has a toc fitted and replace accordingly.
    Hope this helps Allan.

    January 28, 2011 at 8:57 pm #342829
    allan
    Participant

    Re: Samsung p1453 pump

    Yes have both so will check, thanks Allan

    January 29, 2011 at 12:15 am #342830
    leavemetogetonwithit
    Participant

    Re: Samsung p1453 pump

    Did one of these a while back. Although might have been p1253. It had a toc.
    Mike.

    January 29, 2011 at 6:46 pm #342831
    funkyboogy
    Participant

    Re: Samsung p1453 pump

    does the standard askol not have toc built into winding …

    i must check …

    i would say if they are good enough for zanussi etc – they will be good enough for samsung ..

    ally

    January 30, 2011 at 2:09 am #342832
    leavemetogetonwithit
    Participant

    Re: Samsung p1453 pump

    funkyboogy wrote:does the standard askol not have toc built into winding …


    Unfortunately it doesn’t. Cheapest way I’ve found to get a pump with a toc is the Plaset WMA pump, but it won’t fit everything.
    Also, it’s easy to get fooled by pictures, and even when you have the pump in your hand, because often an offset terminal or a little moulding change to accomodate a toc are present but when you lever off the plastic cover there’s none there 🙁 .
    Where possible I take the old coil from the old pump and fit it to a new one but there are several different coils. And then they change the barrel design so you can’t swap them.
    Mike.

    January 30, 2011 at 10:16 am #342833
    funkyboogy
    Participant

    Re: Samsung p1453 pump

    just looked at a new samung pump , made by askoll – looks the same as the standard askoll but they have an orange impellor, and it has a toc

    badge on it says
    mod m47 art 292080

    maybe some clever pattern supplier could look into supplying an alternative

    January 30, 2011 at 4:37 pm #342834
    Steven
    Participant

    Re: Samsung p1453 pump

    Don’t know the part no of hand, but Qualtex do askol with toc.

    Steven

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.