Hotpoint BCI450c

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BCI450c

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • February 10, 2011 at 9:13 am #60937
    admin
    Keymaster

    I couldnt find these in the error code listing
    the appliance blew the fuse and not lights 3&5 atre flashing (5 led display)

    Thanks

    Simon

    February 10, 2011 at 10:47 am #344207
    iadom
    Moderator

    Re: Hotpoint BCI450c

    It has the 100 bit PCB in it.

    Error codes 😉

    Jim.

    February 10, 2011 at 2:05 pm #344208
    admin
    Keymaster

    these relate to the 4 and 7 led version, this one is a 5 led version,
    do i only use led’s 2 to 5 then?

    February 10, 2011 at 4:49 pm #344209
    iadom
    Moderator

    Re: Hotpoint BCI450c

    Sorry, all five lights used, sent you something. 😉

    Jim.

    November 27, 2011 at 8:44 pm #344210
    Payney
    Participant

    Re: Hotpoint BCI450c

    Hi all,

    I have exactly the same happened with one of these and could do with fault code list if any one has one.
    Had blown fuse and then flashed lights 3 and 5.

    Any help greatly received.

    Thanks
    in advance

    Mark

    November 27, 2011 at 9:49 pm #344211
    iadom
    Moderator

    Re: Hotpoint BCI450c

    I have repaired the link in the second post, it went AWOL in the move to the new forum software. 😉

    3+5 is a classic no heat fault, its either the heater or the PCB 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time, megger the heater, if it is OK then its the PCB.

    November 29, 2011 at 3:50 pm #344212
    Rograbbit
    Participant

    Re: Hotpoint BCI450c

    Hi guys. I see a lot of posts regarding the 100 bit pcb. Haven’t repaired any yet. Do you buy these configured or do you have to have the card reader etc?

    November 29, 2011 at 4:36 pm #344213
    Criscold
    Participant

    Re: Hotpoint BCI450c

    Nice simple job – Pre Configured

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.