CI555WH Spin Problem

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › CI555WH Spin Problem

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 24, 2011 at 2:17 pm #61281
    johnnyhoz
    Participant

    This one does the program ok but won’t cut into spin, tried it on manual spin still the same, it tries to wind up but cuts in and out whether with a load or without with a clicking noise from the control board. Changed the board, brushes are about half worn, checked the wiring to the motor still the same.
    Only thing left is the motor unless I’m missing something, has anyone come across this fault before, any help I would be greatful

    John

    February 25, 2011 at 7:34 am #345545
    Steven
    Participant

    Re: CI555WH Spin Problem

    Have you checked for any earth faults?
    You say brushes half worn, is there carbon dust in motor tracking out?

    The only other thing have you checked heater and thermisitor?

    Steven

    March 8, 2011 at 8:39 pm #345546
    cornwell40
    Participant

    Re: CI555WH Spin Problem

    OOps. Just seen this one. Had exactly the same fault last year. wire on the motor plug (lowest one IIRC) broken in the insulation.

    Tony

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.