bosch WAE 2416SGB/08 FD8708

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch WAE 2416SGB/08 FD8708

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • February 25, 2011 at 8:01 pm #61321
    richardable
    Participant

    sorry to be so vague on this one…
    user says lights flash but no action…where do i start…?

    February 26, 2011 at 9:34 am #345668
    Bernie
    Participant

    Re: bosch WAE 2416SGB/08 FD8708

    I did a search in the KNOWN ERROR CODES and found this hope it helps

    Bernie

    Bosch WAE24165 . Refering to the 5 spin lights;

    Light
    Door 1
    Poor drain 1&4
    No fill 1&5
    Motor fault 1,3 &5
    Water in base 1,3,4&5

    Presumably this may apply to all WAE series with 5 spin lights

    February 26, 2011 at 10:52 am #345669
    richardable
    Participant

    Re: bosch WAE 2416SGB/08 FD8708

    bernie
    thanks..i’ll post result later.
    richard

    March 5, 2011 at 11:10 am #345670
    richardable
    Participant

    Re: bosch WAE 2416SGB/08 FD8708

    update on flashing lights
    when you choose ANY programme and without pressing any option buttons or the start button, after approx 1 second ALL the spin speed lights and rinse hold light flashes in unison…also the WASH light flashes too..again in unison with the others. the w/m has been switched off over night..no change.. pressing any of the buttons..including start make no
    difference either.
    thanks
    richard

    March 5, 2011 at 11:59 am #345671
    nomadPaul
    Participant

    Probably the boards goosed mate . If you basically have every led flashing , it normally means the microprocessor has failed on the control module.

    March 6, 2011 at 2:37 pm #345672
    keithwilliams
    Participant

    Re: bosch WAE 2416SGB/08 FD8708

    if all the lights are flashing it may have same fault as hotpoint boards. look for blown capacitors. full explaination is in the simple pcb repair thread at top of page

    March 6, 2011 at 6:06 pm #345673
    Martin
    Participant

    Re: bosch WAE 2416SGB/08 FD8708

    keithwilliams wrote:if all the lights are flashing it may have same fault as hotpoint boards. look for blown capacitors. full explaination is in the simple pcb repair thread at top of page

    Nah! Nah!…definitely not the same cure as Hotpoint boards, the eeprom is goosed! 😥

    March 8, 2011 at 11:01 pm #345674
    leavemetogetonwithit
    Participant

    Re: bosch WAE 2416SGB/08 FD8708

    Got to be worth a look at the caps. And if the eprom is goosed, what caused it?
    Mike.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.