panasonic na 14va1 error code h41

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › panasonic na 14va1 error code h41

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 10, 2011 at 11:07 am #61591
    kenlawred
    Participant

    Can any tell me what the h41 code is thanks

    March 10, 2011 at 12:30 pm #346732
    Jackal
    Participant

    Re: panasonic na 14va1 error code h41

    Unit is not able to ascertain the spin speed of the motor during the spin cycle.

    Technical states replace the 3D sensor (PNo. AXW24N-7FH0) or Main PCB, (PNo. AXW24C-7GZ06) but I would check to ensure its pumping out correctly first.

    My engineers advise that the unit tries to ramp up into spin during the pump cycle then realises its not yet empty and ramps down again. PCB cannot handle this up and downward cycle so aborts the data feed and throws error H41 at you.

    Hope this helps but if you need the Service Manual, PM me and I will send it over.

    Regards

    Jackal

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.