HAIER HW-C1460TVEMEU

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HAIER HW-C1460TVEMEU

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 17, 2011 at 4:56 pm #61712
    mjw1208
    Participant

    Hope someone can advise on this machine ,machine will wash but even fully loaded doesn’t like to go into full spin mode and when completed cycle usually error message shows END UNB . How do we clear the unbalanced error message and start again with it ? know these are very tempremental for this but it’s becoming a pain in the A**e ,a match with a gallon of petrol would be a waste at £6.50 on todays prices

    March 17, 2011 at 5:16 pm #347334
    Jackal
    Participant

    Re: HAIER HW-C1460TVEMEU

    The UNB message will clear it self and simply advises it didn’t spin properly after the fourth rinse due to a perceived Out of Balance (OOB) potential.

    These units have a temperamental main PCB which senses the possible OOB and bang off it goes.

    Sadly, if there is nothing obvious such as uneven floor, under loaded machine etc, it sounds like a dodgy PCB.

    Regards

    Jackal

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.