Indesit Evolution WE13 fault code F09

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Indesit Evolution WE13 fault code F09

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 3, 2004 at 8:09 am #6174
    admin
    Keymaster

    Can anybody please tell me what fault code F09 means on an Indesit WE13 washing Machine? – Many thanks

    September 3, 2004 at 8:24 am #116059
    Penguin45
    Participant

    F09 is usually board fault with the computer – I’d get some help!
    Regards,
    Penguin45.

    September 3, 2004 at 8:28 am #116060
    Dave_Conway
    Participant

    Re: Indesit Evolution WE13 fault code F09

    It basically means there is an electronic (software) error, try resetting it as per you user manual, or I’ve posted the sequence several times in various threads if you don’t have the manual.

    If that doesn’t work, you will need an engineer to check it our for you. Let us know how you get on with the resetting please.

    Dave.

    September 3, 2004 at 11:41 am #116061
    admin
    Keymaster

    Re: Indesit Evolution WE13 fault code F09

    I’ve looked for threads with the re-setting info but can’t find any!
    Could you please enlighten me as to how this is done on the WE13?

    Thanks,

    Roland.

    September 3, 2004 at 3:23 pm #116062
    Dave_Conway
    Participant

    Re: Indesit Evolution WE13 fault code F09

    Turn the washer off, then turn the dial to any black dot. Now turn the washer on and you should see the power indicator light flash 3 times. On the third flash turn washer off again and select a wash programme. Turn the washer on again and after a couple of seconds the machine should start.

    September 7, 2004 at 11:51 am #116063
    admin
    Keymaster

    Re: Indesit Evolution WE13 fault code F09

    Hi Dave ,

    Thanks for the resetting instructions……unfortunately though, there are no
    Black dots on the dial, only 11 programme settings and the usual spin and rinse settings!!……so wherever you set the dial, it is on one of these programmes! – When I turn the power on the whole LCD display comes on
    with all the symbols showing but nothing is flashing, about 5 seconds later
    the F-09 fault code comes up! – If I then press the start/reset button the
    machine starts but only seems to perform programme 9. Have you got any ideas or should I just bin it and go and buy another machine and hope it lasts longer than the 17 months that this one has!!!

    Roland.

    September 7, 2004 at 12:05 pm #116064
    Martin
    Participant

    Re: Indesit Evolution WE13 fault code F09

    Roland,

    The problem is likely to be an error between the Programme Module and the Control Module. The only option at this stage is to ‘reset’ the programme setting! From memory on this beast you need to push and hold the ‘Start Button’ for at least 5 seconds.

    That should reset it completely for you to set whatever prog you like. If it doesn’t??? then you have a problem with the Electronics somewhere that could be expensive if you are not covered by extended warrantee 🙁

    Martin

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.