Bosch WFR3269GB/05

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WFR3269GB/05

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 1, 2011 at 1:50 pm #62007
    Criscold
    Participant

    Called and replaced Bearings on the above machine, all went ok – tested machine B4 replacing panels – worked OK
    after refitting panels and refitting machine into space the machine filled, heated, and pumped but no motor action.

    The door release strap had caught behind plinth so that the door interlock didn’t operate correctly
    rectified and retested still no motor action, anyone know if the machine would lock out because of this and is there a reset procedure for this machine.

    Thanks
    Colin

    April 1, 2011 at 2:41 pm #348389
    Martin
    Participant

    Re: Bosch WFR3269GB/05

    Can’t fully answer your questions Colin except to say that as far as I’m aware there is no reset feature on this model. There is a test procedure of course but I’m not sure that would help you at this point in time. What I do know is that the interlock controls the Motor, Pump and Inlet Valves so I suspect that possibly you may have also trapped the wiring to the interlock as well as the release strap?

    It’s a 3 phase motor on this beast and you may like to inspect the motor inverter module also? 💡

    April 1, 2011 at 4:03 pm #348390
    Criscold
    Participant

    Re: Bosch WFR3269GB/05

    Thanks Martin

    I have now got the machine in the workshop and managed to find test cycle info and comes up with error 10 but can’t find this error not listed – can anyone help on this.

    I will post test info later

    Thanks

    Colin

    April 1, 2011 at 6:21 pm #348391
    Martin
    Participant

    Re: Bosch WFR3269GB/05

    Error code 10 = No motor action. 🙁

    April 2, 2011 at 8:21 am #348392
    Criscold
    Participant

    Re: Bosch WFR3269GB/05

    I was hoping that error 10 would get me nearer the problem, As the cables seem to be ok I’m thinking that I may have damaged the interlock, there are 7 connections on the lock and it would help if I could get hold of a diagram or information on the connections to the lock. If anybody could help with this.

    Thanks

    Colin

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.