- This topic has 4 replies, 3 voices, and was last updated 15 years ago by
.
-
Posts
-
hi all,been to two wml50 p ukr date code 80 washers with same fault this week,just thought it might be a common problem on this model,basically they leak on the front left side,although didnt when i tested them, i cleaned out disp inner and outer checked disp hose all usual stuff,reduced inlet pressure ,leveled out etc,holes in disp top seem clear but i know some can spray at a funny angle causing leak,anyway just a thought if anyone has any ideas,, dont think much to the design ..sealed tub,,,welded front panel,, not very repair friendly 😯 thanks
Re: hotpoint wml50
i used to work for hotpoint/indesit and yes it is a common fault that you will struggle to cure, they leak from the dispenser area, changing disp may cure for a while but it is the design-as you say not very repair friendly
Re: hotpoint wml50
if its the rotary type dispenser there is a modified dispenser out that cures the leak problem part no is
COO281253
fitted loads for nuisance leaks at dispenser and not had a problem well not with leaking from disp lol…. 😀
- You must be logged in to reply to this topic.